Grader Blades

Viper Grader Blades

Valk

Valk Viper grader blades are heat-treated to give up to four times the wear of carbon steel blades. Valk Viper grader blades are made from a special quality of boron-intensified steel. These blades are through-hardened, not simply flame or case hardened, to achieve longer wear and far greater strength than flame or case hardened can provide.

Valk guarantees Viper grader blades against breakage. Viper grader blades are quenched and tempered to yield a hardness of 44 to 52 Rc scale, and offer superior toughness when compared to other grader blades.

This means reduced down time, reduced changing cost and reduced bolt usage. Valk Vipers are designed for the new generation of high-powered equipment that demands more from a blade.

All blades are AASHO-modified punched with 11/16th or 13/16th square countersunk holes on 6" centers. Sizes available include:

  • 5/8x6" CDB
  • 3/4x6" CDB
  • 5/8x8" CDB
  • 3/4x8" CDB
  • 1X8" CDB

High-Carbon Steel Grader Blades

The Valk C-1084 line of high-carbon steel grader cutting edges and end bits is available for all makes and models of equipment, in both standard and heavy-duty sizes. The C-1084 may be ordered in four edge designs and in any length.

Most common of all grader designs, curved double-bevel grader blades are available in seven sizes. Curved double-bevel cutting edges improve penetration and rolling action, and reduce the possibility of moldboard distortion through increased rigidity of the moldboard assembly. Available in the following sizes:

    Valk
  • 1/2x6"
  • 3/4x6"
  • 1/2x8"
  • 3/4x8"
  • 5/8x6"
  • 1x8"
  • 5/8x8"

When superior surface penetration is required, Valk serrated blades provide unequalled performance. Economical by design, cutting edges can be ordered with angle left, angle right, or straight serrations. Available in the following sizes:

    Valk
  • 1/2x6"
  • 3/4x6"
  • 1/2x8"
  • 3/4x8"
  • 5/8x6"
  • 1x8"
  • 5/8x8"

For heavy-duty grader blade applications, flat double-bevel cutting edges can be ordered in 1x10", 1 1/4x10" and 1 1/2"x10" sizes.
All grader blades in the C-1084 line are multiple punched for 100% accuracy with center or edge hole placement.
The C-1084 is the economical choice for general purpose applications.
Grader end bits are available for all graders.
Left: Regular and overlayed end bits. Right: Reversible overlay end bit.