|
Accessories
Valk manufactures a complete
line of wear parts for all snowplow lines, including moldboard shoes,
nose pieces, plow shoes, and wing shoes.
Fasteners
If the blade doesn't fit
right and stay in place, even the best cutting edge will fail. Valk has
available
quality fasteners which hold true and help prevent slippage which could result
in cutting edge failure.
We offer a complete
selection of cap screws, carriage bolts, plow bolts, track shoe bolts,
hex nuts, spring lock washers and rivets.
Fasteners are available in
Grade 2, 5, and 8. When severe operating conditions exist, Grade 8
is recommended.
Hitches
 |
 |
 |
|
UN300 |
FH900 |
HD900 |
|
This universally designed hitch is adaptable to most trucks
up to 1 ton capacity. Especially made for SP and VW series
snowplows. |
This model is mounted to the front bumper and also truck
underframe by means of push bars. Plowing forces are
transmitted through front bumper and push bars to truck
frame. Light duty LD900 version also available. |
The HD900 hitch is a front bumper to frame mounted hitch
that is well suited for heavy duty use. |
 |
 |
 |
|
BH700 |
MD700 |
CO210 |
|
This model is a bumper to front axle hitch designed for
plows weighing less than 1500 lbs. Pushing forces are
transmitted through the bumper and frame. |
The MD700 is a variation of the BH-700 designed to slip over
the front axle. |
The CO210 hitch has been designed for Tilt Cab trucks. The
vertical portion of the hitch telescopes downward to permit
tilting of cab. |
 |
 |
 |
|
UF600 |
NJ200 |
QH100 |
|
This heavy duty structured
underframe hitch transmits all stresses imposed by plow
directly to truck frame close to driving wheels. No push on
front axle. |
The NJ200 hitch is a bumper to
front axle hitch with a special rear swivel adapter to allow
flexing of truck axle without undue strain to hitch or
truck. Hookup lugs are recessed between vertical and
horizontal sections. Well suited for heavy duty as well as
lighter plows. |
This hitch is designed for
quick hookup. Plow is attached without the use of pins or
liftchain. Driver can hook up plow from truck cab. |
 |
 |
|
|
BH200 |
OH-10 |
|
| The BH200
hitch is designed for heavy duty plows weighing 1500 lbs. or
more. Heavy H beam is designed for the horizontal and
vertical members. Wide liftarm helps prevent side chatter. |
The OH-10
heavy duty structural underframe hitch is constructed from
4" H beam. All stresses are transmitted directly to the
truck frame close to driving wheels. No push on front axle.
Lifting portion is integral part of this hitch. |
|
Snowplow Options
|
